First Time using AB's Stroker Keeper for the VG2

[spini]

Ive been testing various mounting approaches for the VG2, and finally got myself a Stroker Keeper from AB. Must admit, I didnt expect much, basically because I couldn’t see how it would allow sufficient up-and-down movement. But Ive now had sessions with it over the last two nights, and was blown away by how much movement there is, and how amazing it feels. My sessions ended up being shorter than usual (ie I came more quickly) largely because there was less fussing around with gear. The experience was more immersive - my attention could remain locked into the fantasy.

Some extra bonuses of the Keeper, is that (1) it also acts as a vacuum seal, and (2) the strap that goes under your balls prevent the VG2 receiver coming off your cock (eg from its going soft, or from pop-off).

The one refinement I’ll try next time is to use some cord/cable attached to the top of the receiver so that it is suspended somewhat. Im mostly using the VG2 lying down, and without it being suspended, it ‘migrates’ around a bit on my legs/tummy as my erection alters from hard to super hard etc. So it would be good to reduce that sideways movement.

[Autoblow_Brian_Sloan]

Thanks for the report on this. Yes, it looks a little bit weird, but it does function exactly as you mentioned, keeping the air in and allowing plenty of up and down movement.Full disclosure, we have just found, I think, the perfect penis sleeve and repurposed it for this function.

When we released this, at first it was made from a different material, and there were reports of the back part snapping. We replaced it with this version, which is much sturdier.

I’m even looking into making a little bit more expensive and robust version made from silicone, but the silicone material needs to be a little bit too thick to allow as much movement as this one does. I think, for the price, it’s providing an excellent value, even if, once in a while, after a lot of use, the back thin part might break.